Electrical Engineering Laboratory
|Newark College of Engineering|
To measure characteristics of a rectifier and a Zener diodes and to understand the difference between an "ideal diode" and a real device. To familiarize students with basic rectifiers and other diode circuits.
Equipment needed from the stockroom: Proto-board, analog universal meter, leads.
1. MEASUREMENTS OF I-V CHARACTERISTICS OF A RECTIFIER DIODE.
a) Measure the I-V characteristic of a rectifier diode or the dependence of current through the diode on voltage across the diode. For measurements with forward diode bias you need a voltmeter and an ammeter; use the analog and the digital meters. An incandescent lamp in series with the diode makes a handy "high power" resistor. Do not burn the bulb (stop increasing current when it becomes bright)! Cover a wide range of current values, from a fraction of a mA to about 100mA. Plot the current as a function of the bias voltage. Make a preliminary graph in the laboratory.
b) Apply a reverse bias to the diode of a few volts to see how large the reverse current is. Even your digital ammeter may not be able to measure a very small reverse current. Can you determine it by measuring voltage across a high value resistor (MΩ) connected in series with the diode? Think which of the two voltmeters to use in this measurement (consider their internal resistances!).
2. ZENER DIODE
Measure the I-V characteristic of a Zener diode with reverse bias. Use an appropriate series resistor (the light bulb may do it) to permit a few tens of mA of current after achieving a breakdown voltage. Make a preliminary graph in the laboratory.
Plot reverse bias characteristic of the Zener diode and determine the Zener breakdown voltage.
3. A DIODE IN A CIRCUIT; THE LOAD LINE
a) Assemble the circuit shown below using the diode which characteristic you just measured. Choose the resistor in a few kohm range. Measure the voltage across it while increasing slowly the power supply voltage to obtain current of a few mA. Measure also the voltage across the circuit (Vs) and across the diode.
Fig. 8.1 A diode in a circuit with a resistor
a) Repeat a) for a lower resistance (100 ohm) and in a few tens to 100 mA range. Do not exceed the power rating of the resistor (1/4 W). Make a quick calculation of the dissipated power (for example, 100 mA is too much for a 100 ohms small resistor!)
Make the load line plots for the two circuits tested in a) and b), using the diode characteristic you measured in 1.
Advice: Make sure that the current is in the range you covered in the measurement of the diode characteristic in section 1. If not, you may need to add a few points to the characteristic now. You will need it to prepare the load line plot.
4. DIODE CLAMP CIRCUITS
Assemble circuits shown in Fig. 8.2 and test the output voltage with an oscilloscope while supplying waveforms with different amplitudes to the input. Try a sinewave and a triangle or square wave with different dc bias. The second circuit, known as a diode limiter, is often used to protect inputs of sensitive devices, such as ammeters or high gain amplifiers. Choose R for good clipping performance. Sketch input and output waveforms. Explain how these circuits work (Experiments in 4. should help).
(a) Diode clamp circuit
(b) Diode limiter circuit
Hint: A semi-log graph may be the most informative here, plot it in addition to a standard linear graph.